Worx Nitro WG186E.1, Original Instruction

Page: 19 / 300

19
Cordless Grass Line Trimmer &
Brushcutter, Attachment-Capable
EN
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING:
To be accurate, an estimation of
exposure level in the actual conditions of use should
also take account of all parts of the operating cycle such
as the times when the tool is switched off and when it
is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and
keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration
and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
ACCESSORIES
WG186E.1 WG186E.92
Battery pack
(WA3014)
2 /
Charger (WA3883)
1 /
Spool 1 1
Safety guard
1 1
Brush cutter blade
1 1
Pole hedge trimmer
attachment (WA0220)
/ /
Pole saw attachment
(WA0222)
/ /
Edger attachment
(WA0223)
/ /
Shoulder strap
1 1
Hex key 1 1
Wrench
1 1
We recommend that you purchase your accessories
listed in the above list from the same store that
sold you the lawn trimmer. Refer to the accessory
packaging for further details. Store personnel can
assist you and offer advice.
ASSEMBLY & OPERATION
NOTE:
Before using the tool, read the
instruction book carefully.
Action Figure
Assembly
Assembling the Trimmer Shaft
Insert the screw into the hole, then
tighten the locking knob
See Fig. A
Assembling the Auxiliary Handle and
Safety-stop Handle
See Fig. B1,
B2
Assembling the Safety Guard
Insert the metal bracket into the slot
on the safety guard, then secure the
guard in place using the screw and
hex key.
See Fig. C
Assembling the Shoulder Strap See Fig. D
Installing and Removing the Battery
Pack
NOTE:
• This machine will only run
when 2 batteries are installed. It
is recommended to use the same
two batteries and charge the
two batteries at the same time.
• When two batteries are used
with different amp hours or
charge level, the machine will
run to the lowest common
denominator.
* It is recommended that using
4.0Ah or above battery pack for
better performance and longer
run time.
See Fig.
E1, E2
Checking the battery charge
condition
NOTE:
Fig. E3 only applies for the
battery pack with battery indicator
light.
See Fig. E3
Charging the battery pack
NOTE:
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More details
can be found in charger’s manual.
See Fig. E4
Battery power indicator on the
machine
See details in BATTERY STATUS
section
See Fig. E5
Operation
To start
WARNING! The cutting head
continues to rotate after the
trimmer has been switched off; wait
until it has completely stopped then
lay down the tool.
Press the lock-off button first, then
press the switch trigger to start the
machine.
See Fig. F