16
EN
MESSAGE
CAUSE
ACTION
Wheels motor fault!
Press START to reset.
Wheel motor is blocked in
some way.
Turn power off and take Landroid to an area free from obstacles.
Turn power on. Press start.
If the error message is still displayed, turn power off. Turn Landroid
upside-down and check if there’s anything preventing the wheels from
rotating.
Remove any obstruction, turn Landroid upright, turn power on.
Upside down! Press
START to reset.
This could have happened
when Landroid came into
contact with a sloping
surface which made it
overturn.
Turn Landroid upright and remove any obstacle that might have caused
Landroid to overturn.
Mower trapped! Press
START to reset.
Landroid is trapped.
Turn power off.
Take Landroid to an area of your lawn free of obstacles, then turn power
on. Press start.
If the error message is still displayed: turn power off, turn Landroid
upside-down. Check if there is anything preventing the wheels from
rotating.
Remove any obstruction, turn the Landroid upright, turn power on.
Mower lifted! Press
START to reset.
Landroid is lifted up.
Turn power off.
Take Landroid to an area clear of obstacles, turn power on. Press start.
If the error message is still displayed: turn power off, turn Landroid
upside-down and check there’s anything that can cause Landroid to be
lifted up.
Remove any possible object, turn Landroid upright, turn power on.
Battery voltage too
low! Please change
battery.
Battery exausted.
In this case you must turn Landroid off and place it in the charging
station, then ‘Emergency charging’ will be displayed and it will start
charging. If the battery error still persist, your battery is damaged and
need to be changed.
Wire missing! Press
START to reset.
Machine can’t find
boundary wire signal.
If the LED light is red, check if the boundary wire is well connected to the
clamps on the charging pile.
If the problem persists, check that the boundary wire hasn’t been cut.
Battery temperature
out of range!
Please wait.
Temperature is too high
(more than 55
0
C)or too
low(less than 0
0
C) when
charging.
Place the charging station in a shady area or wait until it reaches the
normal temperature.
Can’t find charge
station press START
to reset.
Boundary wire is beyond
its maximum length (300m
or machine doesn’t have
enough power to go back
to charging station.
Take Landroid to the charging station.
Mower locked!
With the ‘Lock Function’
enabled, if your Landroid
does not receive a signal
from your Wi-Fi router for 3
days, then it gets locked as
a security measure.
This could be because
your router lost its power or
because you changed your
Wi-Fi router or network
provider.
Please reconnect Landroid to the Wi-Fi networtk it has been originally
paired with. If this is not possible, contact Cutomer Service.
