Worx Professional WU434, Manual

Page: 12 / 138

12
pArAllel GUiDe (See Fig.e)
The parallel guide (8) enables exact cuts along a workpiece edge
and cutting strips of the same dimension.
bevel CUTS (See Fig.F)
Set required bevel angle between 0° and 56°. Do not use the depth
of cut scale when making bevel cuts due to possible inaccuracy.
poCKeT CUTTiNG (SoFT MATeriAlS oNly)
(See Fig.G1 AND G2)
This operation requires much skill with a saw and must only be
carried out by a competent person.
Warning:
The blade teeth are exposed during this operation so
proceed with extreme caution.
Clearly mark the area to be cut. Set the depth of cut on the saw.
Position the saw over the marked area with the front edge of the
base plate resting on the work surface and cutting guide aligned with
marked line on workpiece. Ensure the blade is not touching but is
close to the work surface. The moving lower guard must be rotated
open by using lever. Switch the saw on and gently swing the blade
down into the material but maintain a pivoting force on the front edge
of the base. The moving lower guard can now be released for normal
action of the guard.
Maintenance
remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
1
2
3
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
Environmental protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.