Worx Professional Versacut WU420, Manual

Page: 15 / 58

15
maintenance. There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all working controls free
of dust.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
Periodically clear dust and chips from guard and base to ensure
proper performance.
Troubleshooting
Symptom Possible Causes Possible Solution
Tool will not start
when operating the
on/off switch.
Power cord not
plugged in.
Power cord is
broken.
Carbon brush has
worn down
Check to make sure
power cord is connected
well into a working outlet.
Unplug the power
cord. Replace it using a
qualified maintenance
person.
Replace the carbon
brush using a qualified
maintenance person.
Cutting depth is less
than that is set.
Sawdust
accumulated at
the rear of the
base. Shake out sawdust.
Consider connecting
a vacuum for dust
collection.
Blade spins or slips
Blade is not tightly
engaged with the
spindle.
Remove the blade,
and reassembled it as
described in
INSTALL /
CHANGE THE BLADE
section.
Blade will not cut a
straight line.
Blade is dull.
Blade is not
mounted properly.
Saw is not being
guided properly. Mount a new, sharp
blade on the saw.
Check that blade is
properly mounted.
Use an edge guide.
Blade kicks back
when beginning a cut
Blade is not
spinning fast
enough Allow the saw blade to
reach full speed prior to
beginning a cut