Worldlawn WYW36FS481VH, Operator'S Manual

Page: 23 / 40

HYDRO-DRIVE WALK BEHIND MOWER
23
the handle in the engaged position after the
engine has been started.
ADJUSTING THE CUTTING HEIGHT
The cutting height of the mower deck is
adjustable from 1.5 to 4.5 inches in 1/4 inch
increments for FIXED deck models, and 1.5 to
4.5 inches in 1/2 inch increments for
FLOATING deck models. Before attempting to
make any adjustments always make sure that
the mower is on level ground, the park brake is
on and the ignition key has been removed.
For the FIXED deck models use the supplied
chart and accompanying diagram located in the
back of this manual to establish which aspects
need to change to produce the desired result.
For the FLOATING deck models you must use
the pin holes as a guide to correctly set the
height. Lift up on one side of the deck and
secure it with the latch. Lift the other side and
secure it. Move all 4 pins to the holes that will
produce the desired cutting height. Lift the
deck, one side at a time, the latches will release
automatically, and lower it to the pins.
TRANSPORTING
TRANSPORTING A UNIT
Use a heavy-duty trailer or truck to transport the
machine. Lock brakes and block wheels.
Securely fasten the machine to the trailer or
truck with straps, chains, cable, or ropes. Be
sure that the trailer or truck has all necessary
lighting and marking as required by law.
Secure a trailer with a safety chain.
CAUTION
This unit does not have proper turn signals,
lights, reflective markings, or a slow moving
vehicle emblem. Driving on a street or
roadway without such equipment is
dangerous and can lead to accidents
causing personal injury. Driving on a street
or roadway without such equipment may
also be a violation of State laws and the
operator may be subject to traffic tickets
and/or fines.
Do Not drive a unit on a public street or
roadway.
WARNING
Loading a unit on a trailer or truck increases
the possibility of backward tip-over.
Backward tip-over could cause serious
injury or death.
•
Use extreme caution when operating a
unit on a ramp
•
Use only a single, full width ramp; Do
Not use individual ramps for each side of
the unit.
•
If individual ramps must be used, use
enough ramps to create an unbroken
ramp surface wider than the unit.