3
1.6.4
Maintain or replace safety and instruction labels,
as necessary.
1.6.5
Run the machine a few minutes after throwing
snow to prevent freeze-up of the auger/impeller
blades.
1.7 Snow thrower Safety
The following list contains safety information specific
to products or other safety information that you must
know.
1.7.1
The rotating auger/impeller can cut off or injure
fingers or hands. Stand behind the handles and away
from the discharge opening while operating the snow
thrower. Keep your face, hands, feet, and any other
part of your body or clothing away from moving or
rotating parts.
1.7.2
Before
maintaining,
adjusting,
cleaning,
inspecting, troubleshooting, or repairing the snow
thrower, stop the engine, remove the ignition key, and
wait for all moving parts to stop. Disconnect the
wire from the plug to prevent someone from
accidentally starting the engine.
1.7.3
Perform only those maintenance instructions
described in this manual. If major repairs are ever
needed, contact an Authorized Service Dealer.
1.7.4
Purchase only genuine replacement parts and
accessories.
1.7.5
Before leaving the operating position, stop the
engine, remove the ignition key, and wait for all
moving parts to stop.
1.7.6
If a shield, safety device, or decal is damaged,
illegible, or lost, repair or replace it before beginning
operation.
1.7.7
Do not smoke while handling gasoline.
1.7.8
Do not use the snow thrower on a roof.
1.7.9
Do not touch the engine while it is running or
soon after it has stopped because the engine may be
hot enough to cause a burn.
1.7.10
Do not change the governor settings on the
engine.
1.7.11
When storing the snow thrower for more than
30 days, drain the fuel from the tank to prevent a
potential hazard. Always store fuel in an approved
fuel container. Remove the key from the ignition
switch before storing the snow thrower.
1.8 Safety and Instructional Decals
Important
:
Safety and instruction decals are located near areas of potential danger. Replace damaged decals.
1. Do not place your hand in the chute. Stop the engine before leaving the operator’s position. Use the tool clear
the chute.
Summary of Contents for WS2690BSE
Page 2: ......
Page 13: ...8 3 Product Overview FIG 5 Refer to engine instruction book FIG 7 FIG 6 ...
Page 27: ......