*SET BANK M: Use [ < ] or [ > ] button to select Bank M field. While in Bank M field, use
[VALUE] dial to select desired value, Pressing
[ENTER]
to confirm the value.
*SET BANK L: Use [ < ] or [ > ] button to select
‘
Bank L
’
field. While in Bank L field, use
[VALUE] dial to select desired value, Pressing
[ENTER]
to confirm the value.
6. EDIT
When you press
[EDIT]
button
，
The LCD display
‘
CTLdata1
’
the EDIT MODE be activated.
in this mode, you can change the parameters of the pads, knobs and sliders. The EDIT
MODE allows you to fully customize and optimize your controller for the best desired
performance.
The different parameters that you can edit are organized under two different pages on the
display and are described below. Depending on which event type you select on Page 1,
you will be given different parameters which you can edit on Page 2,
To select the controller you wish to edit, just move any slider, knob or hit a pad
–
This will
prompt the screen to display the properties of that particular controller. You can select the
desired controller with the
[VALUE]
dail. Pressing [ENTER] will confirm the value.(In edit
mode,There is no message can be sent).
6.1 PAD EDIT
The pads can either be set to transmit Note information,
Press the pad that you would like to edit, Use [ < ] or [ > ] button to select Note field, The
LCD display
‘
Pad_note
’
, turn the
[VALUE]
dial to select
‘
NOTE
’
. Press
[ENTER]
to
confirm the
‘
Note
’
..
