Page
– 4
H2
H3
H1
(H1) Allen Bolt x16
(H2) Washer x16
Assembly Steps
Step 1
-
Lay the Table
Top
(A) upside down on a non-marring surface (packing foam).
-
Align holes on the Leg (B) bracket
with corresponding holes on the bottom of Table Top (A).
-
Secure Leg (B) using 8 pcs Washers (H2), 8 pcs Spring Washers (H3) and 8 pcs Allen Bolts (H1). Repeat the same
step to install the other Leg (B). Do not fully tighten until all bolts have been inserted.
-
Fully tighten all Allen Bolts (H1) with the supplied Allen Key (T1).
-
Place the complete table upright.
Step
2
Note : This Table comes with pre-attached adjustable levelers on the bottom of each Leg (B).
