World Helmsman WH-M100, User Manual

Page: 6 / 12

6
WH-M100/ WH-M150/ WH-M300/ WH-M500 network camera
User Manual
Step 2:
Electrification test
a. Before connecting the power, make a final check to confirm correct wiring.
b. When powering on the camera, it will automatically execute self testing by doing firstly Tilt
up/down scanning, and then Pan horizontal scanning, then camera will stop at the Preset Point 1.
Upon completion of these, the self testing is well done.
Precautions
This product is normally installed in an elevated position. Installation work should comply with local safe
regulations.
Proper safety precautions and protective measures shall be taken for installing the camera.
For the personnel safety sake, carry out electrification and product test only after completion of
installation work.
Using IR Remote Control Function
This PTZ dome camera has built-in IR Receiver, which will allow user to use our IR Remote Controller
(Model: WH-RT100, optional device) to control the movement of Mini Speed Dome PTZ Camera. (The
operation of such IR Remote Controller can be found on the user’s manual of WH-RT100)
RS485 Wiring Method
Two RS485 wiring methods can be used according to actual needs. We recommend the following wiring
methods for avoiding mal function of RS485 control.
1. RS485 serial connection
This method connects speed dome PTZ cameras in sequential manner where the first camera connects
to the second and then the second to the third, and so on until the last one. A terminal resistance is
connected to the last camera to form a closed loop, see the following illustration: