Operation of the rotary hammer drill
16
AFTER SALES SUPPORT
16
GB
IRE
GB
0845 872 2740
IRE
019022605
1. Take the rotary hammer drill out of the packaging.
2. Check whether the rotary hammer drill or the individual parts exhibit damage.
If this is the case, do not use the rotary hammer drill. Contact the manufacturer at
the service address specified on the warranty card.
3. Check to make sure that the delivery is complete (see
fig. A
,
B
,
D
,
E
and
the list
on
page 6
).
Basic cleaning
1. Remove the packaging material and all protective foils.
2. Clean all parts of the rotary hammer drill before first use as described in the chap-
ter “Cleaning”.
Operation of the rotary hammer drill
WARNING!
Risk of accident and injury!
There is a risk of accident and injury in the event of accidental acti-
vation/deactivation when inserting and removing tools as well as
when transporting and cleaning the rotary hammer drill.
− Before inserting and removing tools, pull the mains plug to
prevent the rotary hammer drill from accidentally activating.
Never touch the rotating collar or the inserted tool.
The collar does not come to an immediate standstill, but continues
to rotate for a while after the device has been switched off.
NOTICE!
Risk of damage!
When performing overhead work, dust and other contaminants
may penetrate the chuck and clamping chuck and damage it.
− Before inserting the tool, push the dust collector over the tool
shaft so that it collects the drill dust.
− Place the dust collector
16
on the tool shaft so that the keyhole in the dust col-
lector points towards the tip of the tool.
