Cleaning and maintenance
25
3. Let the compressor cool off completely.
4. Vent the compressor using the connected pneumatic tool (see
Fig. A
).
5. Have a collecting container ready to collect the old oil.
6. Use the open-ended spanner to loosen the oil drain plug
13
(see
Fig. A
and
H
).
7. If necessary, tip the compressor slightly and let the oil drain completely into the
collecting container.
8. Screw the oil drain plug back onto the compressor and use the open-ended span-
ner to tighten it again.
9. Add new oil as described in the chapter “Adding oil”.
Adding oil
1. Make sure that the On/Off switch
3
is set to the “
OFF 0
” position (see
Fig. G
).
2. Before adding oil, pull the mains plug out of the socket to disconnect the compres-
sor from the power supply.
3. Let the compressor cool off completely.
4. Vent the compressor via the connected pneumatic tool.
5. Screw the oil plug
4
anticlockwise out of the threading of the oil fill opening
26
(see
Fig. A
and
E
).
6. Add enough oil so that the oil level is between the “max.” and “min.” mark (see
Fig. H
).
7. Then screw the oil plug clockwise into the threading of the oil fill opening (see
Fig. E
).
