8
Assembly
wechseln.
1) Changing mounted accessories
Parts list (figure A)
The numbering of the tool parts refers to the illustration on the graphics page.
2) Fitting a sanding sheet to the sanding pad
3) Extraction of dust/waste
1. On/off switch
2. Adjuster wheel for oscillation speed
3. Extraction connector
4. Extraction tube
5. Accessory holder
6. Clamping screw and washer
7. Plunge saw blade
8. Allen key
9. Sanding sheet
10. Sanding pad
11. Segment saw blade
12. Scraper
13. Additional handle
A
1
4
7
2
3
5
6
10
13
8
11
12
9
CGN300A / 90810
After Sales Support
0845 872 2740
GB
019022605
IRL
www.coreservice.co.uk
RISK OF INJURY. Always unplug the tool after use and before changing
accessories. Wear protective gloves when changing the tools or
accessories.
Contact with the tool/accessories can cause injuries.
Remove any accessory already fitted. Do this by undoing Clamping screw and washer 6
using Allen key 8 and remove the accessory.
Place the accessory (e.g. plunge saw blade 7) on the accessory holder 5.
NOTE: You can place the accessory in any possible position on the accessory holder 5.
Secure the accessories with the Clamping screw and washer 6 in the desired position.
Tighten Clamping screw 6 with the Allen key 8.
Check that the accessory is firmly seated. Incorrectly or insecurely mounted accessories
can come loose in use and injure you.
The sanding pad 10 has a Velcro backing plate so that sanding sheets can be quickly and
easily mounted.
Position the sanding sheet 9 so that it is firmly held on one side of the sanding pad 10.
Then fit the sanding sheet to the backing plate.
Do not use the tool on materials containing asbestos, as this is carcinogenic.
