AFTER SALES SUPPORT
21
1300 855 831
MODEL: DBG 150 PRODUCT CODE: 51893 02/2016
AUS
DBG 150
Cleaning and maintenance
•
The grinding wheel should rotate “into” the object being sharpened.
NOTE:
Excessive pressure may damage the tool, cause the motor to overheat, and
prematurely wear down the grinding wheel.
ON/OFF Switch (Figure 8)
Plug the device in a power outlet.
The bench grinder features a front access ON/OFF switch (13) for convenience and
safety. After switching on the equipment wait for the equipment to reach its maxi-
mum speed of rotation before commencing with the sanding/grinding work.
Sharpening twist drill bits (Figure 9)
Drill bits are best sharpened on a sharpening jig (available at most hardware stores).
Begin on one side of the point at the existing angle, then twist the bit while maintain-
ing contact with the grinding surface. Sharpen only the tip.
This technique requires considerable practice, so take your time and make a few
“dry runs” first with the grinder off. Be sure to maintain the original cutting edge
angle as this is important to the efficiency of your bits.
Sharpening chisels and screwdriver blades (Figure 10)
When sharpening chisels and screwdrivers, work rest should support the chisel at
the correct angle against the wheel.
IX. Cleaning and maintenance
m
WARNING!:
Unplug the device from the power outlet for all maintenance and cleaning opera-
tions.
m
WARNING!:
When servicing, use only identical replacement parts. Use of any other parts could
create a hazard or cause product damage.
m
WARNING!:
Always wear eye protection with side shields marked to comply with ANSI Z87.1.
Failure to do so could result in objects being thrown into your eyes resulting in possi-
ble serious injury.
Cleaning
•
Keep all safety devices, air vents and the motor housing free of dirt and dust
as far as possible. Wipe the equipment with a clean cloth or blow it with com-
pressed air at low pressure.
•
We recommend that you clean the device immediately each time you have