7. WIRIS ETHERNET STREAM SDK GUI APPLICATION
7
WIRIS Ethernet Stream SDK GUI Applica on
This chapter contains informa on about WIRIS Ethernet Stream SDK GUI applica on, which was developed to
demonstrate possible usage of this SDK.
7.1 Introduc on
7.1.1 Installa on
The app can be downloaded directly from Workswell website.
WIRIS Ethernet Stream SDK GUI is fully open source, therefore you can access all source files, which can serve as
an example for developing your own applica on. You can find them on GitHub:
h ps://github.com/So wareWorkswell/EthernetStreamSDKGUI
Note that the most important part of this project is ”ControllerCore” class (with its dependencies like Thread
classes and NetworkClient class), which demonstrates basic usage of SDK, other files are pla orm dependent
and may not be so interes ng
7.1.2 First launch
On first startup applica on requires you to:
Fill in your WIRIS IP address
Fill in your ac va on code
A er filling IP adress and clicking OK, applica on will try to contact your WIRIS device, this step can fail if your
device is unreachable or your Wiris Firmware is too obsolete and is not supported by the applica on.(Applica on
will always show you the cause)
When connected to WIRIS via HDMI, IP address and mask can be changed in
Advanced - System se ngs
When successfully connected, applica on may ask you to fill in your ac va on code (but only if it has never been
ac vated in the past)
Figure 7.1 – WIRIS Ethernet Stream SDK GUI - Connec on Window
E-mail and Web
[email protected]
www.workswell.eu
Mobile:
+420 725 877 063
ID:
Reg. No.: 29048575
VAT No.: CZ29048575
Headquarters
U Albrechtova vrchu 12
155 00, Prague 13
Czech Republic
Revision 1.1 EN, 11
th
Sept, 2019
All pictures are only for illustra on.
Real values may vary.
38
