Assembly Instructions for The Worksman Stretch Mover™ Industrial Tricycle:
Congratulations! You have purchased one of the most unique, useful, practical
industrial cycles ever made. The Worksman Stretch Mover is the latest member of the
Worksman Business Cycle System. Your Worksman Stretch Mover™ Industrial
Tricycle has been hand made by American Craftspeople at our Ozone Park New York
City Factory. We take great pride in each and every Worksman Business Cycle that
we manufacture and appreciate your support. Please read this manual carefully prior
to performing the simple finishing assembly and prior to riding. Keep these
instructions as our parts list is contained within this document which you will need for
future reference.
Carefully remove the tricycle from the carton. You will notice the Stretch Mover
tricycle is mostly pre-assembled at the factory. Some finishing assembly is required
.
INSTALLING PEDALS:
Pedals are marked on the shaft with either an
“L”
or
“R”
denoting left or right. The
“R”
pedal fits on the right sprocket
side of the crank arm. Tighten clockwise. The
“L”
pedal fits on the left side
of the crank arm. Tighten counter clockwise (left hand thread).Securely
tighten. Recommended torque 275 IN. LBS.
CAUTION:
tightening in the
wrong direction will damage the crank and pedal threads.
SEAT ADJUSTMENTS:
Although the seat is already installed at the factory, adjust the height to your desired
level by loosening the square head frame seat bolt (4909M). Re-tighten at desired height. Make
sure a minimum of 3 1/2” of the post remain in the frame tube. Never adjust post above this
Level. Adjust angle of seat with nose raised slightly. Tighten seat clamp securely. (240 IN. LBS.).
H
ANDLEBAR
A
DJUSTMENT
Install handlebar stem (55A) into the fork steering tube with the handlebar clamp facing forward. The stem
must be inserted far enough to reach the minimum insertion line. Tighten the stem bolt slightly at this point.
Loosen the handlebar clamp nut and slide the handlebar through the clamp centering the knurled center
section of the handlebar into the clamp. Position the handlebar to the desired angle and tighten
clamp securely. Recommended torque is 300 IN. LBS. Adjust the handlebar rotation so that it is
perpendicular to the front wheel when it is perfectly straight. Tighten stem bolt securely. Recommended
torque 240 IN. LBS. Be sure not to over tighten as damage to the parts may occur causing steering failure.
Attach brake hand lever to the handlebar (either left or right depending upon the
rider’s preference) Make sure brake cable is not tangled in anyway.
Please familiarize yourself with the features of your new cycle prior to riding. Read Rule For Safe Riding and made
certain that you are familiar with the brakes prior to riding.
Always Place cargo securely on the rear platform to make certain
that items will not shift or fall during operation of cycle. Use Tie
Down Straps when necessary.
O
NLY USE GENUINE
W
ORKSMAN
C
YCLES REPLACEMENT PARTS
