Operating Instructions–VAG 1761/1
Compressed air gun
For processing Spray-on seam sealant D 476 KD7 A3 and other 310 ml cartridges
6. Spray function
The gun sprays when both adjusting screws are open.
Red adjusting screw = Turn screw completely towards (+)
Blue adjusting screw = Turn screw completely towards (+)
7. Seam sealant
The jet is guided
vertically
with a separation of
approx. 4 cm
and
at a right angle
to the seam.
8. Coating
The jet is guided
vertically
with a separation of
approx. 20 cm
and
at a right angle
to the surface.
9. Fine spraying
The flow of material must be reduced for coating large
areas with a fine coat.
Red adjusting screw = Turn screw completely towards ( – )
10. Applying beading without spraying
The spray air is to be turned off if a bead of material
needs to be applied.
Close blue adjusting screw!
Turn screw towards ( – ) to stop.
11. Reducing flow of material
The flow of material can be reduced using the red adjusting
screw.
Red adjusting screw = Turn screw towards ( – )
12. How can the position of the adjusting screw be
recognized?
Black studs with a height of 2.5 mm, corresponding
exactly to the height of one thread, are molded on the
shells of the handle.
• The grooves of the adjusting screws indicate the position.
• When the screw is open, the groove sits above the stud.
• When the screw is closed, the groove sits below the stud.
13. Multi-functional application
Conventional 310 ml cartridges can be tensioned using
the black DK union nut.
The blue adjusting screw remains closed when processing.
The red adjusting screw regulates the flow of material.
(continued on next page)
6
9
10
11
12
7
8
ca. 4cm
