6
13
S A F E T Y I N S T R U C T I O N S
(continued)
Keep safety signs clean and legible at all times.
Replace safety signs that are missing or have become illegible.
Replaced parts that displayed a safety sign should also display the current sign.
Safety signs are available from your Distributor or Dealer Parts Department or the factory.
Be sure that the installation area is clean and dry.
Be sure temperature is above 50˚F (10˚C).
Decide on the exact position before you remove the backing paper.
Remove the smallest portion of the split backing paper.
Align the sign over the specified area and carefully press the small portion with the exposed sticky backing in
place.
Slowly peel back the remaining paper and carefully smooth the remaining portion of the sign in place.
Small air pockets can be pierced with a pin and smoothed out using the piece of sign backing paper.
Be certain the tractor or skid steer is in neutral or park position before starting engine.
Always shut off power unit and shift to “Park” or set brakes when leaving unit. Always lower bucket or
attachment to ground, relieve all hydraulic pressure. Remove key when leaving equipment unattended. Park
in level area.
Before operating equipment: if you have any questions regarding the proper assembly or operation, contact
your dealer or representative.
How to Install Safety Signs:
SAFETY SIGNS
STARTING AND STOPPING SAFETY
S A F E T Y S I G N S
REPLACE
SAFETY DECALS
IF DAMAGED
OR MISSING!
Safety is a primary concern in the design and
manufacture of our products. Unfortunately, our
efforts to provide safe equipment can be wiped out
by a single careless act of an operator.
In addition to the design and configuration of
equipment, hazard control and accident prevention
are dependent upon the awareness, concern, pru-
dence and proper training of personnel involved in
the operation, transport, maintenance and storage of
equipment.
It has been said, “The best safety device is an
informed, careful operator.” We ask you to be that
kind of an operator.
When working on side hills, DO NOT RAISE
LOADER TOO HIGH. Keep an eye on terrain
changes. Keep load low.
ALWAYS OBEY ALL SAFETY RULES!
ALWAYS BE CAREFUL!
S A F E T Y I N F O R M AT I O N
