Worksaver GLBH-2072, Owner'S/Operator'S Manual

Page: 18 / 32

INSTRUCTIONS
(continued)
MODEL JDBH-2072R
ATTACHMENT TO PRIME MOVER
——————————————————
The Bale Hand Model JDBH-2072R is specifically
designed for John Deere 400 and 500 style carriers.
NOTE: Procedure is the same for all attachments.
Bucket attachment shown.
ATTACHING
1. Extend bucket tilt cylinders to angle attaching brackets
forward.
NOTE: Angle must be greater than that of the
brackets on the rear of the bale hand.
2. Drive forward, adjusting loader height and position
until the top of the loader bracket engages the hooks
(C) on the bale hand.
3. Slowly retract the bucket tilt cylinders and raise the
loader so the lower lock pins (F) engage the hole in
the holder strap (E).
4. Continue to retract the tilt cylinders and raise the
loader until the main frame of the bale hand is vertical.
5. Engage tractor parking brake and/or place transmis-
sion in PARK. Shut off tractor engine and remove key.
6. Install the quick-lock-pin (A) into the pins (F) on each
side of the bale hand.
Installation is now complete.
NOTE: On attachments with two pins (F), the 400
series loaders will utilize the upper pin and the 500
series loader will utilize the lower pin.
DETACHING
1. Engage tractor parking brake and/or place transmis-
sion in PARK. Shut off tractor engine and remove key.
2. Remove the quick lock-pin (A) from each side of
attachment. Store pins in storage position (B).
3. Start engine and lower the bale hand to the ground.
Extend bucket tilt cylinders until pin (F) releases from
holder strap (E) on each side of attachment. Lower the
loader until holder brackets are free from the hooks.
Back tractor away from attachment.
4. Set parking brake and/or place transmission in PARK.
Shut off engine and remove key.
17
CAUTION! ALWAYS CHECK LATCH PINS
BEFORE TILTING OR OPERATING
ANY ATTACHMENT.
REPLACE SAFETY SIGNS
IF DAMAGED OR MISSING.