6 of 10
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Attach Base to Worksurface - Non-
Workrite Tops
Note: For 2-Leg Corner and 120° Worksurface
Mounting Instructions, go to:
www.workriteergo.com/instructions
Position Leg Assembly
centered left to right and
6.125" from the front of the
worksurface, making sure the
frame runs parallel with the
back edge of the worksurface.
Use a ⅛" drill bit to drill
pilot holes at the four corner
locations. You may wish to
mark your drill bit so you
do not drill any more than
¾" deep and damage tour
worksurface top.
Do not drill all the way through worksurface!
Attach at the four corner locations using #12 × ¾" Pan Head Laminate
Top Screws (I). If you use an electric screwdriver, be sure it is on the
lowest torque setting to avoid stripping the holes in the top.
With frame set positioned and the four corner screws secure, drill pilot
holes first then attach the frame set using the remaining #12×¾" Pan
Head Laminate Top Screws (I).
Tighten securely.
>¾"
6
.125"
6
.125"
23"- 30"
Center
Parallel t
o edge
front
5
a
b
a
a
b
b
b
b
Note: Avoid trip or tip hazards!
For uniquely shaped, non-rectangular worksurfaces, it is the
installers responsibility to position the worksurface to minimize
extended overhangs and position feet fully under the worksurface.
3 screws per
Short Bracket
2 screws per End Bracket
(2 installed in Step 5c)
16 screws per
Rear Bracket Assembly
c
c
d
d
d
d
c
I
#12 × ¾" Pan Head
Laminate Top Screw
Hardware at actual size
I
I
I
I
c
c
