Workrite ergonomics ACC-WM-MT G Series Assembly/Installation Instructions Download Page 3

Page: 3 / 3

Workrite Ergonomics | 800.959.9675 www.workriteergo.com

3 of 3

1500454 Rev A

DO NOT DRILL

DEEPER THAN ½”

Use screw driver or drill/driver to attach mounting hooks to bottom side of the worksurface

with 4 (four) of #12 ¾” Pan Head Screws

Insert Mesh Trough into Hook Mounts

Insert both metal rods into the hook mounts.

Metal rods should make a *click* sound once

fully seeded in the hook mount

Hardware at actual size

#12 × ¾” Pan Head Screws

Summary of Contents for ergonomics ACC-WM-MT G Series

Page 1: ...ugh With Rods 1 B1 Mesh Trough Hook 2 B2 Mesh Trough 12 Pan Head Screws 4 Cordless Drill Tools Required Drill Bit 2 Phillips Bit Screwdriver or Driver Drill B1 A B2 Assembly Installation Instructions Mesh Cable Trough ACC WM MTXX G Insert Aluminum Rod into user side of both hook mounts 1a ...

Page 2: ...Determine mounting placement underneath the worksurface Back of Mounting Hook should be flush with the back edge of worksurface Use pen pencil to mark the pre drill location for the 4 screws Once pre drill location is marked remove Mesh Trough from Mounting Hooks DO NOT DRILL DEEPER THAN Pre drill two pilot holes per Hook using Drill bit 1b 1b 2a 2a 2a 1c ...

Page 3: ...ver to attach mounting hooks to bottom side of the worksurface with 4 four of 12 Pan Head Screws Insert Mesh Trough into Hook Mounts Insert both metal rods into the hook mounts Metal rods should make a click sound once fully seeded in the hook mount 2b 2b 2b 3 Hardware at actual size B2 12 Pan Head Screws ...