Workrite Ergonomics Conform Sit-to-Stand Arm Assembly/Installation Instructions Download Page 3

Page: 3 / 4

3 of 4

Workrite Ergonomics | 800.959.9675 www.workriteergo.com

Attach Arm to Single Pole Adaptor

5.1 Place the Sit-Stand Articulating Arm (F) onto the Pin on

the Single Pole Adaptor (E).

5.2 Attach using The Pin and Washers set aside in Step 4,

and tighten using the 5 mm Allen Wrench (J).

5.3 Set the tension screw with the 2.5 mm Allen wrench (H)

so the Arm moves freely but remains in place during

use.

5.4 Place the Pivot Cover Cap(G) on top of pivot hole.

Remove Single Pole Adaptor Bolt & Washers

Remove the Bolt & two Washers from the Single Pole Adaptor (E)

and set aside for

Step 5. Leave the Pin and Spacer in place.

5.1

5.2

5.3

Bolt

Washers

Pin

Spacer

Remove

Replace

Behind Single

Pole Adaptor

Summary of Contents for Conform Sit-to-Stand Arm

Page 1: ...1 Using C Clamp handle loosen the C Clamp on the Pole Base A wide enough to fit over the edge of the worksurface 1 2 For thinner tops Adjust the C Clamp lower plate if it is too wide to fit over the e...

Page 2: ...he C Clamp handle loosen the C Clamp bolt on the Pole Base A 2 2 Using 5 mm Allen Wrench J remove the Bolt from the underside of the Base in order to remove the entire C Clamp in one piece 2 3 Remove...

Page 3: ...using the 5 mm Allen Wrench J 5 3 Set the tension screw with the 2 5 mm Allen wrench H so the Arm moves freely but remains in place during use 5 4 Place the Pivot Cover Cap G on top of pivot hole 4 R...

Page 4: ...til the monitor reaches a balanced adjustment To decrease capacity turn counter clockwise until the monitor reaches a balanced adjustment 7 2 Adjusting Arm Capacity opposite of above To increase capac...