2 of 4
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
3
Attach Single Pole Adaptor to Pole
3.1 Slide the Single Pole Adaptor (E) onto the 14" Pole (A). You may
need to loosen the Clamp Screw using the 5 mm Allen Wrench (J)
to slide it onto the Pole.
3.2 Attach at approximately the right height and tighten in place
using the 5 mm Allen Wrench (J).
2
HD Base Grommet Mount Installation
Note:
A grommet hole or small hole is required in your worksurface to install the grommet mount. Drill a
.375″hole in worksurface if needed. The minimum distance from the edge of the worksurface to the center of the
grommet hole is 2.125". The grommet mount can accommodate existing grommet holes up to 3" in diameter.
2.1 Using the C-Clamp handle, loosen the C-Clamp bolt on the Pole Base (A).
2.2 Using 5 mm Allen Wrench (J), remove the Bolt from the underside of the Base in order to remove the entire
C-Clamp in one piece.
2.3 Remove the Adhesive Pad's (B) backing. Apply the adhesive side to the bottom of the Desk Base, aligned with the
front edge of Base, and stick in place.
2.4 Insert Grommet Bolt (C) into the Pole Base (A). Tighten with 4 mm Allen Wrench (I).
2.5 Insert the Grommet Bolt (D) through the grommet hole of worksurface. Make sure the mount does not overlap
the edge of the worksurface.
2.6 From under the worksurface, place the U-Bracket (D) onto the Grommet Bolt (C) then place the M8 Steel Washer
(C) followed by the Wing Nut (C) onto the Bolt and tighten Wing Nut to secure the base to the desktop.
Worksurface
edge
A
E
J
J
3.1
3.2
Clamp screw
C
C
C
Tighten
Tighten
Loosen
Loosen
Remove
C-Clamp
Remove
Bolt
A
I
C
D
B
J
2.3
2.4
2.6
2.5
2.1
2.2
