5 of 7
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Attach the Monitor to the Monitor Arm VESA Plate
Remove the monitor from its stand. Keep the original screws
to mount to Conform Arm.
Attach the VESA plate to the VESA holes on your monitor. Use
the screws from your monitor if possible.
Repeat for other arm.
Monitor Tilt Capacity Adjustment
If your monitor is too light or too heavy for the factory set capacity, the monitor will tilt too easily. If this is the
case, you need to adjust the tension.
Adjusting Tilt Capacity
To increase ca) turn clockwise using a 5 mm
Allen wrench until the monitor reaches a balanced
adjustment.
To decrease capacity (-) turn counter-clockwise until
the monitor reaches a balanced adjustment.
Repeat for other arm.
5
a
a
b
b
Remove
6
Tilt capacity
Important Note:
It is strongly recommended to use the mounting
screws provided by the monitor manufacturer if possible. If longer screws are
required, use either part (B) 10 mm, or (C) 6 mm screws supplied. Always use
the shortest screws possible to avoid damage to the monitor.
100 mm VESA standard, use
4 outer corner holes.
75 mm VESA standard, use
4 inner corner holes.
