4 of 7
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Monitor Gap Adjustment (continued)
With Pivot Head removed, place the Wedge
Washer (E) onto the post, with the thicker side
of the washer toward the pole.
Reassemble the Pivot Head as shown with
the Pivot Screw going through the bottom of
the Arm Assembly into the Head. Use the 4
mm Allen wrench included with the base to
tighten the screw.
Repeat for a second arm.
Note: Adjust as needed to reduce gap between monitors.
Once the Pivot Head is installed onto the Slotted Pivot Adjustment area, you can install the monitors to the VESA
Mount in the following step, then adjust the monitors in or out for ideal placement.
Maximum 17" actual width monitor
Maximum 17" actual width monitor
Maximum 17" actual width monitor
4
f
f
g
e
e
Thicker side of washer
toward the pole
Gap
Adjust
Adjust
Installed
E
