NOTE:
Drain the contents back into the original container. Do not
store chemicals in the tank.
CLEANING THE TANK AND SPRAY LANCE ASSEMBLY
1. Fill the tank about one-third full with clean water. A small
amount of mild household detergent may be added.
NOTE: Never use flammable chemicals or abrasive cleaning
agents to clean the tank.
2. Wipe the outside of the tank with a clean, dry cloth.
3. Reinstall the battery pack. Spray until the tank has been
emptied. Make sure to direct the spray toward an area that
will not be damaged by the spray solution.
4. Refill and repeat the procedure with clean water. It may be
necessary to rinse the tank more than once, then drain again
as directed above.
5. Allow all pieces to completely dry before reinstalling parts and
storing the unit. Always reinsert strainer before replacing cap.
CLEANING THE SPRAY HEADS
If the nozzle becomes plugged, use the steps below to clear.
1. Remove the battery pack.
2. Unscrew and remove the spray head from the spray lance.
3. Push a small wire through the cross holes to clear any debris.
If necessary, rinse the cross holes and nozzle with clean
water.
4. Wipe the nozzle and cross holes with a clean dry cloth and
reinstall the nozzle.
REPLACING SEALS
WARNING:
Always follow procedures for draining and
cleaning the tank before replacing the seals. Make sure
you wear rubber gloves when reaching into the chemical
tank. Wash your hands thoroughly afterwards. Failure to
follow these instructions can result in a rash, skin
irritation, or other serious personal injury if you directly
contact some chemicals.
Over time, seals can harden and crack, which can allow
the chemical sprayer to leak. A set of replacement seals
is included. Refer to the image shown for the location of
each of the seals, then replace as needed to address
any leaks that develop.
Additional sets of replacement seals can be ordered by
contacting customer service.
NOTE:
Unthreading the connections to replace the seals
could allow liquid to escape, so always clean the
chemical sprayer thoroughly as previously described
before replacing the seals.
STAORAGE THE SPRAYER (see fig. 14)
After cleaning, storage the sprayer in the dry place, do
not put the sprayer in the sun shine place.
The sprayer lance can be put on the hang hook(7), or
put on the tank cap. See fig. 14.
ENVIRONMENT PROTECTION
In order to prevent the machine from damage during transport, it is delivered in a sturdy packaging. Most of the packaging
materials can be recycled. Take these materials to the appropriate recycling locations. Take your unwanted machines to your
local dealer. Here they will be disposed of in an environmentally safe way.
Li-ion batteries can be recycled. Deliver them to a disposal site for chemical waste so that they can be recycled or
disposed of in an environmentally friendly manner.
Discarded electric appliances are recyclable and should not be discarded in the domestic waste! Please actively
support us in conserving resources and protecting the environment by returning this appliance to the collection
centres (if available).
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in conformity with the following standards or standardized
documents: EN60745-1:2009+A11:2010; EN60745-2-5:2010; EN55014-1:2006/+A1
：
2009+A2:2011; EN55014-2:1997/+A1
：
2001+A2:2008; in accordance with the regulations 200
6/42/ЕEС, 2014/30/ЕEС.
NOISE/VIBRATION Measured in accordance with EN60745 the sound pressure level of this tool is <85dB(A) and the sound
power level is <96dB(A) (standard deviation: 3 dB), and the vibration is <5,33 m/s
2
.
