Step 7 – Front Mudguard
Remove the packaging from the mudguard if you haven’t
already done so.
Remove the nut from the bolt just behind the front brake as-
sembly, this also secures the light, so be careful not to let the
light fall. Offer up the mudguard tag to the rear side of the
frame and then finger tighten the nut back into position.
Secure the silver arms to the front forks using the bolts pro-
vided, and then adjust the height if required and then tighten
the nut securing the tag. It may be necessary to angle the
silver arms to get the best clearance from the tyre, as shown
below.
Step 4 – Front Brakes
Fit the curved metal section into the receptacle on the left of
the brake assembly. You may need to loosen the cable
clamp on the right side of the brake assembly to do this.
Re-tighten the brake cable clamp ensuring the correct ten-
sion and the correct position of the brake-pads with relation
to the wheel rim. You may need to adjust the position of the
brake pads, use the supplied Allen key to do this. For a guide
on adjusting your brakes, see the support section of our web-
site at www.wooshbikes.co.uk
Now is a good time to release the front suspension which is
locked for transit purposes, this is done by twisting the cap
above the right fork. Failure to observe this step will result in
an uncomfortable ride and excessive rattling of the bike.
