FORM:SBTM OWNERS MNUL
REV: 8-03-10
APPR BY: EW
49
4. Erratic or Blinking Display
•
Probable causes: Low line voltage; too much load on the same line.
•
Make sure treadmill is on a dedicated electrical circuit.
•
Possible static problem / spray with staticide.
•
Display power supply on Interface board is defective.
5. Squeaking Sounds:
Possible causes:
•
Noisy bearing(s). Try greasing or replacing the bearing.
•
Drive belt rubbing against the drive pulley, try greasing the edge of the drive belt
with a little all purpose grease.
•
Running belt rubbing against drive pulleys, try lightly greasing the teeth on the
drive shaft, and let the treadmill run at a slow speed for a couple of minutes to
spread grease evenly. (NOTE: Too much grease will make a mess and will
accumulate dust.)
•
Check for a defective guide roller or Z roller bearing on the bearing rail, replace if
defective
