Woodway 4Front, Service Manual

Page: 55 / 97

05/2016 – SM-MT-EN-02 55
1. Unplug treadmill from the power source. Ensure that it cannot be turned back on.
2. Remove the side covers (see Section 6.10).
3. Remove the handrail assembly from the frame (see Section 6.10).
4. Lay 2 lifting bars on the floor (AC bracket side) next to the machine.
5. Using two persons, carefully tip the machine on its side. Be careful when tipping the
machine on its side to not set the fuse holder or elevation gear bolt on anything, as
this will damage them (Pos. 4, 5, 6).
6. Use the ¾” box wrench to loosen the jam nuts (Pos. 2) that hold the foot in posi-
tion.
7. Remove the foot (Pos. 1).
1. Using the 12” combination square, adjust to the distance between the bottom of the
frame and the bottom of the elevation block foot (Pos. 3).
2. Place the combination square on the frame next to where the foot will go. Adjust
the screw in the foot assembly until it is the same height as the combination square
and tighten the jam nut (Pos. 1, 2). Repeat for all 4 feet.
3. Lay the machine back down.
4. Re-install the handrail assembly (see Section 6.10).
5. Re-install the side covers (see Section 6.10).
6.10 Contact Heart Rate Replacement
Fig. 55 Contact heart rate replacement
1. Contact plate
2. Plastic grip
3. Heart rate grip screw
4. Heart rate grip nut
5. Wire tab
 Standard screwdriver, small
 Phillips head screwdriver
 Needle-nose pliers
Removal
Installation
Tools Needed