29
Bevel cuts
Fix the work piece with a clamp as shown in the picture. Set the desired angle with the ar-
rester. Make sure that the riving knife is parallel with the blade. Tighten the arrester. Start
the machine and start cutting by pushing the blade carefully downwards.
Skew cuts
Install the work support for mitre sawing in the desired groove and set the desired angle.
Start the machine and move the work piece carefully towards the blade using the work sup-
port. ATTENTION: Always secure the workpiece. Never secure the workpiece on that part
that is cut off.
Adjustment of the riving knife
The riving knife can be set to two different positions. In order to obtain maximum grooving
capacity, the riving knife is set to the lowest position, which limits the maximum depth of cut.
Distance between the table and upper end is approx. 10 cm. In order to obtain the maximum
depth of cut, the riving knife is set so that its top is no more than 2 mm above the highest
tooth tip of the saw blade. Set the riving knife so that the closest point is between 3 and 8
mm away from the saw blade.
Loosen the riving knife screw and move the knife according to the chosen sawing type.
Tighten the screw.
