Woodstock SHOP FOX W1808, Owner'S Manual

Page: 21 / 64

-19-
W1808/W1809/W1810 Cyclone Dust Collectors
SE
T
U
P
The following instructions apply to all three models
except where noted. To begin assembling the W1810, start
at
Step 1
. To begin assembling the W1808/W1809, start at
Step 2
.
To assemble the dust collector, do these steps:
1.
Model W1810 Only: Connect the upper stand legs
with the lower braces, using (16)
3
/
8
"-16 x
3
/
4
" hex
bolts, (32)
3
/
8
" flat washers, and (16)
3
/
8
"-16 lock
nuts, as shown in
Figure 13
. Only finger tighten for
now
.
2.
Connect the upper braces to the upper stand legs,
using (16)
3
/
8
"-16 x
3
/
4
" hex bolts, (32)
3
/
8
" flat wash-
ers, and (16)
3
/
8
"-16 lock nuts, as shown in
Figure
14
.
Note:
On Model W1808/W1809, the lower braces
will not be installed until
Step 7
on
Page 20
.
3.
Attach the cyclone funnel to the intake barrel with
a barrel gasket between the two, as shown in
Figure
15
, with (12)
5
/
16
"-18 x 1" hex bolts, (24)
5
/
16
" flat
washers, and (12)
5
/
16
"-18 hex nuts.
Assembly
Figure 13.
Upper stand legs connected to
lower stand braces, Model W1810.
Upper Stand Leg
Lower Brace
Figure 14. Upper braces attached to stand
assembly, Model W1810.
Upper Brace
Figure 15.
Cyclone funnel attached to
intake barrel.
Gasket
Cyclone
Funnel
Intake
Barrel