-19-
N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/
FG
<
I
8
K@FEJ
Fg\iXk`feK`gj
The following tips will help you safely and effectively
operate your bandsaw and help you get the maximum life
out of your saw blades.
?fi`qfekXc:lkk`e^
Use the work stop to quickly and accurately cut
multiple pieces of stock to the same length (see
=`^li\)'
).
•
Clamp the material firmly in the vise jaws to ensure
a straight cut through the material.
•
Allow the blade reach full speed before engaging
the workpiece. Never start a cut with the blade in
contact with the workpiece (see
=`^li\)(
).
•
Chips should be curled and silvery. If the chips are
thin and powder like, increase your feed rate (refer
to the
D\kXc:_`g@ejg\Zk`fe:_Xik
on
GX^\).
).
•
If the chips are burned, reduce the blade speed.
•
Wait until the blade has completely stopped before
removing the workpiece from the vise, and avoid
touching the cut end—it could be very hot!
M\ik`ZXc:lkk`e^
•
Workpieces that cannot be properly supported or
stabilized without a vise should not be cut in the
vertical position. Examples are chains, cables, round
or oblong-shaped workpieces, workpieces with
internal or built-in moving or rotating parts, etc.
•
Make sure that the vertical table assembly is
securely fastened to the bandsaw frame so it will
adequately support the workpiece.
•
Always keep your fingers away from the blade and
always hold the workpiece securely in your hand
(
=`^li\))
).
•
Adjust the blade guides as close as possible to the
workpiece to minimize side-to-side blade movement.
=`^li\)'%
Work stop and lever.
=`^li\)(%
Proper bandsaw horizontal
starting position.
=`^li\))%
Proper bandsaw vertical
starting position.
NOTICE
Release the blade tension at the end of the day to
prolong blade life.
Summary of Contents for SHOP FOX W1715
Page 44: ...42...
Page 45: ...N Fne i j DXelXc D J eZ...
