Woodstock SHOP FOX W1677, Owner'S Manual, Page: 16 / 64

-14-
W1677/W1711 10" Table Saw
SE
TU
P
Your new table saw has been carefully packaged for safe
transporting. When unpacking, remove the red shipping
braces that hold the saw to the pallet. If you notice the
machine has been damaged, please contact your autho-
rized
SHOP FOX
®
dealer immediately.
Unpacking
SETUP
The following is a description of the main components
shipped in the table saw box. Lay the components out
to inventory them. Note: Some parts and hardware may
already be installed on the machine. Make sure to check
the machine when you use this inventory list.
Box Inventory (Figures 12 & 13) Qty
A.
Saw Base Unit ..............................................1
B. Extension Wings ...........................................2
C.
Cabinet Cover ..............................................1
D. Lock Knob ...................................................1
E.
Handwheel ..................................................1
F. Miter Gauge ................................................1
G.
Blade Guard/Splitter ......................................1
H. Dado Table Insert .........................................1
I.
Standard Table Insert .....................................1
J. Dust Port ....................................................1
K.
Arbor Wrench ..............................................1
L. Support Shaft ..............................................1
M.
Blade Guard Brackets .....................................2
N. Handwheel Handle ........................................1
O.
Switch Support Bracket ...................................1
Hardware and Tools Qty
• Flat Head Screw
5
⁄
16
"-18 x 1" (Switch Bracket) .......1
• Flat Washer
5
⁄
16
" (Switch Bracket) ......................1
• Hex Nut
5
⁄
16
"-18 (Switch Bracket) .......................1
• Tap Screws 10-24 x
3
⁄
8
" (Dust Port) ....................4
• Set Screws
5
⁄
16
"-18 x
3
⁄
8
" (Brackets on Shaft) .........2
• Hex Bolt
5
⁄
16
"-18 x 1
1
⁄
2
" (Brackets on Shaft) ..........2
• Flat Washers
5
⁄
16
" (Brackets on Shaft) .................4
• Lock Washers
5
⁄
16
" (Brackets on Shaft) .................2
• Hex Nuts
5
⁄
16
"-18 (Brackets on Shaft) ..................2
• Hex Bolts
5
⁄
16
"-18 x 1" (Guard/Splitter Install) .......2
• Flat Washers
5
⁄
16
" (Guard/Splitter Install) .............2
• Hex Wrenches 3, 4, 8mm ......................... 1 each
• Flat Wrench ................................................1
Inventory
Figure 13. Table saw loose parts.
Figure 12.
Saw base unit.
A
H
O
I
J
K
L
M
N
B
C
D
E
F
G