-2-
Model W1671 (Mfd. Since 7/11)
Complete the steps below, then go to
Page 9
in the
Owner's Manual
and proceed with the
Mounting
instructions.
To attach head and column assembly to base,
do these steps:
Revised Assembly Steps
1.
Set base on a flat, stable surface.
2.
Insert
(2) M14-2 x 40 base bolts into pivot
slot from underneath base, as shown in
Figure 3
.
3.
Position head and column assembly over
pivot slot, align bolts with holes in assem-
bly base, and lower assembly into position,
as shown in
Figure 4
.
Note:
Keep headstock facing front of base
to maintain center of balance.
4. Secure assembly to base with (2) 14mm flat
washers and (2) M14-2 hex nuts (see
Figure
5
).
Figure 3.
Base bolts positioned in pivot slot.
Base Bolts
Figure 4.
Assembly mounted on base.
Base Bolts
Figure 5.
Head and column assembly secured to
base.
x 2