-20-
Model M1112 (For Machines Mfd. Since 12/20)
SE
TU
P
Figure 19.
Adjusting for tailstock end
taper.
Move tailstock toward
front of lathe
1
/
2
the
amount of taper.
Looking down from above.
Figure
20
.
Tailstock left adjustment
location.
Adjustment Screw
On Both Sides
8.
Loosen the tailstock lock lever and adjust the
tailstock offset by half the taper by turning the
adjustment set screw (
Figure
20).
Turn another
0.010'' off of the stock and check for taper. Repeat
as necessary until the desired amount of accuracy is
achieved.
NOTICE
DO NOT forget to lock the tailstock to the ways
after each adjustment.