-3-
D4792 Mobile Base Extension Kit (Mfd. 1/18)
7.
Attach foot pedal to each side of support
bracket using (1) M8-1.25 x 50 shoulder
screw and (1) M8-1.25 lock nut (see
Figure 7).
8.
Install extension table onto machine. Place
legs into channel bracket and center legs
along length of channel (see
Figure 8).
9.
Slide extension bar into adapter bracket
and lay it towards (or over the top of) leg
support channel bracket to determine if
you need to cut the extension bar (see
Figure 9
).
— If extension bar does not overlap leg
support channel bracket, proceed to
Step 10.
— If extension bar does overlap leg support
channel bracket, then it is too long and
must be cut to length. To do this, mark
and cut the bar exactly where it crosses
the channel support bracket. Leave
enough length so both ends of bar engage
bolts in adapter bracket and extension
bar bracket.
Figure
8
.
Extension table legs placed in support
channel bracket.
Extension
Table Leg
Support
Channel
Bracket
Leg Support
Channel Bracket
Mark & Cut
Base
Extension
Bar
Figure
7
.
Pedals attached to support brackets.
x 2
10.
Slide extension bar bracket over extension
bar, then attach bracket to center of leg
support channel bracket with (2) M8-1.25 x
16 hex bolts, (2) 8mm flat washers, and (2)
M8-1.25 lock nuts (see
Figure 10).
11.
Center extension bar between both
brackets and attach with (4) M8-1.25 x 16
hex bolts. The extension kit should now
look like the one shown in
Figure 11.
Figure
11
.
Extension kit attached to Model
D4666 Mobile Base.
x 4
Figure
9
.
Extension bar and bracket placed
between base and leg support channel bracket.
Figure
10
.
Extension bar bracket attached.
Extension Bar
Extension
Bar
Bracket
x 2
Foot
Pedal
Adapter
Bracket
