-2-
D4088 Lathe Attachment Instructions
Setup
If you need help with your new drill press lathe attach-
ment, call our Tech Support at: (360) 734-3482.
Tools Needed
................................................
Qty
Wrench 17mm ...................................................1
To setup the drill press lathe attachment, do these
steps:
1.
At each end of the workpiece, drill a
1
⁄
8
" pilot hole
5
⁄
8
" deep.
2.
DISCONNECT DRILL PRESS FROM POWER!
3.
Verify that the drill press table is properly leveled,
and adjust as required.
4.
Place the base so the live center is located in the
center of the drill press table, as shown in
Figure
3
.
5.
Fasten the base to the table with the carriage bolts,
flat washers, and hex nuts, but do not fully tighten
the hex nuts yet.
6.
Install a drill bit or dowel in the chuck, lower the
chuck so the tip of the drill bit or dowel just touches
the point of the live center.
7.
Move the base so the tip of the live center is aligned
with the spindle centerline, as shown in
Figure
4
.
Next, tighten the base hex nuts.
8.
Retract the drill press spindle, and fasten the tool
rest foot onto the base with the cap screw, as shown
in
Figure
5
. Later, use the workpiece to estimate
where to tighten the tool rest in place to achieve
a gap of
1
⁄
8
" to
1
⁄
2
" between the workpiece and the
tool rest.
9.
Double check that all fasteners are tight.
Base
Drill Press
Table
Live
Center
Figure
3
.
Mounting base to drill press
table.
Spindle
Centerline
and
Live Center
Aligned
Figure 4.
Live center to spindle alignment.
Figure
5
.
Tool rest installation and
adjustment.
to
Gap
Foot
Tool
Rest
1 8
⁄
1 2
⁄ "
"
Workpiece
