You will need:
Phillips Head Screwdriver
A.
B.
C.
D.
E.
INCLUDED PARTS:
A. Upright Frame and Gong .................................1
B. Feet ....................................................................2
C. Mallet .................................................................1
D. Phillips Flat Head Screws .................................2
E. Felt Pads ............................................................4
1. Make sure each Foot (B) is
held so that the Leveling
Screws are facing down
and the notch in the Foot is
facing up.
2. Align the pre-drilled hole in each
Foot to the hole in the bottom of the
Upright Frame (A). Insert a Phillips
Flat Head Screw (D) into each leg
of the frame and tighten with a
Phillips Head Screwdriver. Repeat
on other leg.
3. Place the assembled frame in the
location you wish to display your
Desk Gong. If necessary, adjust the
Leveling Screws at the bottom of
the Feet by turning in a clockwise
or counterclockwise direction.
4. Remove the paper from the self-sticking Felt Pads (E), making
sure to leave the adhesive tape layer attached to the felt. It
might be useful to crinkle the paper slightly prior to peeling.
This helps to break its connection to the adhesive, allowing
you to peel the paper without removing the adhesive. Place
one on each Leveling Screw head at the bottom of each Foot.
Notch
Leveling
Screws
