27
Feed handles to the shaft hub.
Screw the feed handles (A) tightly into the threaded holes
in the hub (B).
Installing the chuck, Fig. 9
1 Clean the conical hole in the chuck (A) and the spindle
cone with a clean piece of fabric. Make sure there are
no foreign particles sticking to the surfaces. The slight-
est piece of dirt on any of these surfaces will prevent
the chuck from seating properly. This will cause the
drill bit to wobble“. If tapered hole in the chuck is
extremely dirty, use a cleaning solvent on the clean
cloth.
2 Push the chuck up on the spindle nose as far as it
wiII go.
3 Turn chuck sleeve anticlockwise (when viewed from
above) and open jaws in chuck completely.
4 Legen Sie ein Stück Holz auf den Maschinentisch
und senken Sie die Spindel bis auf das Holzstück ab.
Drücken Sie fest, damit das Futter genau sitzt.
Fastening radial drill press to supporting surface
For your own safety, it is highly recommended to install
the machine on a bench or similar.
ADJUSTMENTS
WARNING:
All the necessary adjustments for the good working of
your drill press have been done at the factory .Please do
not modify them.
However, because of a normal wear and tear of your tool,
some readjustments might be necessary .
WARNING:
Always unplug our tool from power source before any ad-
justment“
Quill return spring.
It may be necessary to adjust your quill return spring if
the tension is such that the quill returns either too ra-
pidIy or too slowly
1 Lower table for additional clearance.
2 Work from left side of drill press.
3 Move the stop nuts (A) down to their lowest position
and lock in place with wrench to prevent quill dropping
while tensioning spring.
BA td 13-16.indd 27
15.04.11 10:58