international 9
erating the tool. Learn the tool’s application and limita-
tions as well as the specific hazards peculiar to it.
• Keep guards in place and in working order.
• Always wear eye protection.
• Ground all tool’s. If tool’s equipped with three prong
plug, it should be plugged into a three-hole electrical
receptacle. If an adapter is used to accommodate a two-
prong recentacle, the adapter plug must be attached to
a know ground. Never remove the third prong.
• Remove adjusting keys and wrenches. Form habit of
checking to see that all adjusting tools are removed from
tool before turning it „on“.
• Keep work area clean. Cluttered areas and benches in-
vite accidents.
• Don’t use in dangerous environment. Don’t use power
tools in damp or wet locations, or expose them to rain.
Keep work area.
• Keep children and visitors away. All children and visitors
should be kept a safe distance from work area.
• Make workshop childproof. With padlocks, master
switches, or by removing starter keys.
• Don’t overcharche tool. It will do the job better and be
safer at the rate for which it was designed.
• Use right tool. Don’t overcharge tool or attachment to do
a job for which it was designed.
• Wear proper appa el. No loose clothing, gloves. Neck-
ties, rings, bracelets, or other jewelry to get caught in
moving parts. Nonslip footwear is recommended. Wear
protective hair covering to contain long hair.
• Always use saffety glasses. Wear safety glasses (must
comply with ANSI Z87.1) Everyday eyeglasses only
have impact resistantienses. Also use face or dust mask
if cutting operation is dusty.
• Firmly fasten your work piece. Use clamping devices or a
vice where convenient. Use both hands for operating the
machine.
• Don’t overreach. Keep proper footing and balance at all
times.
• Maintain tools in top condition. Keep tools sharp and
clean for best and safest performance. Follow instruc-
tions for lubricating and changing accessories.
• Disconnect tools before servicing and when changing ac-
cessories such as bands, bite, cutters, ate.
• Use recommended. The use of accessories or attach-
ments not recommended by the seller may cause haz-
ards or risk of injury to persons.
• Reduce the risk of uninternational starting. Make sure
switch is in „off“position before plugging in power
cord.
• Check damaged parts. Before further use of the tool, a
guard or other part that is damaged should be carefully
checked to ensure that will operate properly and per-
form its intended function check for alignment of mov-
ing parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affecr itw
operation. A guard or other part that is damaged should
be properly repaired or replaced.
• Never leave tool running unattended. Turn power OFF.
Don’t leave tool until it comes to a complete stop.
• DRUGS, ALCOHOL MEDICATION. Do not operate tool
while under the influence of drugs, alcohol or any medi-
cation.
• Make sure tool is disconnected from power supply. While
Motor is being mounted, connected or reconnected.
• WARNING: The fragments generated by certain metal
and metal products can be injurious to your health. Al-
ways operated machinery in well ventilated areas and
