29
PN 55191 (4/22/99)
Front Caster Wheel Installation
(Figure 26)
15
24
22
18
8
1
16
3
20
4
cd3963c
1. Wheel assembly
3. Support plate
4. Caster wheel arm
8. Caster yoke
15. Grease zerk
16. 1/2” x 3--3/4 Cap
screw
18. 1/2” Flanged nut
20. 5/8” x 4 Cap screw
22. 5/8” Flanged nut
Figure 26
. Front Caster Wheel Installation
Remove lock down nut and move discharge chute up
to mount right front arm. Put arm (12) on deck, insert
cap screws (11) through arm and deck, and install
locknuts (13).
Insert carriage bolts (3) through deck and caster arm,
install locknuts (2) and tighten. Tighten locknuts (13)
on cap screws (11).
Move discharge chute to the down position, place
washer on stud and tighten locknut.
Put left front arm (4) on left front end of deck as
shown. Insert five carriage bolts (3) through the frame
and arm and start locknuts (2) on all of them. Tighten
locknuts.
Remove cap screw (14) from caster wheel and yoke
(1) then remove all spacers, washers and spring.
Insert caster wheel and yoke (1) into tube of arms (4
& 12). Install all spacers, washers and spring as
shown and tighten cap screw (14). Repeat for
opposite side.
IMPORTANT
J
Do not operate tractor and mower until the
caster wheel interference check, page 11, has
been performed. If you change tractors, you must
perform the check for that mounting.
(Rev. 6/6/2002)