28
PN 55191 (4/22/99)
Quick Hitch Kit Installation (Optional)
(Figure 24)
2
3
1
5
6
5
7
5
5
5
8
9
5
A
4
1/2 x 4--3/4 HHCS
M6080
1. Offset Link
2. 38--Link Chain
3. 29/32” x 1-7/16” x 1-1/4” Sleeve
4. 1/2” x 6 Cap Screw
5. 1/2” Flat Washer
6. 1/2” x 3/4” x 3-3/8” Sleeve
7. 1/2” Flange Lock Nut
8. 7/8” Sleeve
9. 7/8” Flat Washer
Figure 24
. Quick Hitch Kit Assembly
Note:
This kit allows mower to fit only Cat. 1 standard
ASAE quick hitch.
Attach offset link (1) to mounting pins, using 7/8
sleeve (8) and flat washer (9). Attach upper end of
offset link to pivot link, using 1/2 flat washer (5),
sleeve (6), flange lock nut (7), and 1/2 x 4--3/4 cap
screw.
Remove rear offset links and replace with chains (2).
Cut to required length. Attach chain to top of A--frame
as shown, using 1/2 x 6 cap screw (4), 1/2 flat washer
(5), and nut.
Attach opposite end of chain (2) to rear mower frame
as shown. Cut chain to 37.5” in length. Vary length
slightly as desired. Twist chain to make finite
adjustments in length until unit lifts level. Not do
bottom out the drive on front of deck.
IMPORTANT
J
Failure to to follow instructions may result in
damage.
Install sleeve (3) on mounting pins and retain with Klik
pin.
Optional Front Roller Installation
(Figure 25)
Insert four carriage bolts (7) through the front mower
frame from inside out as shown.
Put roller bracket (2) over bolts then install flange
locknuts (5) on bolts and tighten.
Put front roller (1) in roller bracket and insert roller pin
(4) through bracket and roller.
Install retainer pin (3) in roller pin. Put cap screw (6)
through bracket and retainer pin, install flange locknut
(5) and tighten.
Remove rear offset links and replace with chains (2).
Cut to required length. Attach chain to top of A--frame
as shown, using 1/2 x 6 cap screw (4), 1/2 flat washer
(5), and nut.
Attach opposite end of chain (2) to rear mower frame
as shown. Cut chain to 45 inches. in length Vary
length slightly as desired. Twist chain to make finite
adjustments in length until unit lifts level. Not do
bottom out the drive on front of deck.
IMPORTANT
J
Failure to to follow instructions may result in
damage.
Install sleeve (3) on mounting pins and retain with Klik
pin.
CD3552
1
2
5
6
7
5
3
4
1. Front roller
2. Roller bracket
3. Retainer pin
4. Roller pin
5. 3/8 NC Flange locknut
6. 3/8 NC x 1” Hex head cap screw GR5
7. 3/8 NC x 1” Carriage bolt
Figure 25
. Optional Front Roller Installation
(Rev. 6/6/2002)