36
Assembly
MAN0632 (5/15/2007)
ASSEMBLY
DEALER SET-UP INSTRUCTIONS
Assembly of this cutter is the responsibility of the
Woods dealer. It should be delivered to the owner com
-
pletely assembled, lubricated, and adjusted for normal
cutting conditions.
The cutter is shipped partially assembled. Assembly
will be easier if aligned and loosely assembled before
tightening hardware. Recommended torque values for
hardware are located in the
Bolt Torque Chart, page
56
.
Complete
Dealer Check Lists,
page 34
when you
have completed the assembly.
Full chain, rubber, or steel band shielding must
be installed when operating in populated areas or
other areas where thrown objects could injure peo
-
ple or damage property.
• If this machine is not equipped with full chain,
rubber, or steel band shielding, operation must
be stopped when anyone comes within 300 feet
(92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec
-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition. It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
Make sure attachment is properly secured,
adjusted, and in good operating condition.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Figure 30
.
BB48X
Shipping Configuration
DANGER
WARNING
CAUTION
1. Mounting pin hardware
2. A-Frame bar
3. Upper mounting hardware
(under clutch shield)
4. Diagonal brace
5A. Diagonal brace bar
mounting hole
5B. Tailwheel pivot hole
6. Tailwheel bracket
7. PTO Hanger
9. Tailwheel
10. Height adjustment
12. Bag of hardware
13. Driveline (Shear bolt)
14. Clutch shield
2
5A
5B
6
7
9
10
1
13
3
14
4
(Rev. 4/24/2009)
