background image

SPECIFICATIONS:   

5 persons

   Floor 

size:  9 x 9' (2.7 x 2.7 m)  

   Centre 

height: 

 7’ 

(2.1 

m)

 

 

 

Weight:   

 

25 lb 2 oz (11.4 kg)

A

2

B

KEY
NO.

MODEL NO.  CTC180909-1(076-2936-2)

QTY.
REQ.

DESCRIPTION

Fibreglass pole - Main pole

HFP12.5-188+270+188f, pf

1

1

1

HFP11-174+191+174f, pf

HTFCTC180909-1

HGL1210wTP

Fibreglass pole - Fly (L. Gray) pole

Replacement fly

Gear loft

20

Tent stakes

HMS5-8

PART NO.

REPLACEMENT PARTS

TROUBLESHOOTING GUIDE

PROBLEM

CONDENSATION

SEAM LEAKAGE

MILDEW

REPAIRING A TEAR

FAULTY ZIPPER

FADING FABRIC

FLOOR CONDENSATION

USE OF STAKES

SOLUTION

Condensation occurs when warm, moist air inside tent comes in contact with cooler outside air. Avoid touching walls to reduce  contact leakage. Venting doors and 
windows will reduce condensation. Store wet clothing outside of tent. A battery-powered fan may be helpful. Not applicable to screen houses.

Apply a generous amount of seam-sealer on inside seams. Seam-sealer may be purchased at any local sporting goods store.

To avoid mildew, store tent/screen house ONLY when thoroughly dry. However, if mildew occurs use a soft-bristle brush or sponge with mild dishwashing soap or Fels 

Naptha soap to clean. Let dry thoroughly and a tent-approved water-repellent compound may be applied.

For small tears use a self-adhesive patch kit. We recommend a canvas or awning repair shop for larger tears.

Zippers are self-repairing. If the zipper separates, you can move the slider to the beginning of the zipper tape and rework the zipper. 

Do not leave up in direct sunlight longer than necessary. If left in sunlight for prolonged periods of time, fabric will fade and weaken.

A ground cloth under the floor helps prolong its life, provides additional insulation and moisture protection. The cloth should be smaller than the floor to prevent rain 
from running under the tent.  Not applicable to screen houses.

Stakes should be installed at a 45  angle using a hammer or mallet. Stake loops should be kept taut without over-stretching fabric or webbing. This could cause tears or 
leakage. To remove safely, use a hammer or stake puller. Do not remove by pulling on the fabric.

o

CTC180909-1  06/17

A

B

Summary of Contents for 076-2936-2









Reviews: