2.
Position the burner assembly centered from side to side and as far toward the back wall of the fireplace as
DO NOT DROP ANY LOG PART AS BREAKAGE MAY EASILY OCCUR.
MAY
EASILY OCCUR.
1
.
Carefully remove all parts from the box and
inspect
them
for any damage. Read the Certification Tag attached.
4
.
SOURCE TO CHECK FOR LEAKS. Any leaks must be corrected before proceeding with the installation.
3.
Connect the gas line to the
1/2" flex connector of the Log Set using supplied shut-off valve
(see "Fireplace
Installation")
.
and then watch for air bubbles indicating leaks. DO NOT USE A FLAME OR ANY TYPE OF IGNITION
C arefully remove all log parts from the box and place them onto the floor off to one side of the fireplace.
possible.
Remove the burner assembly from the box and place it onto floor of
your
fire
box
( custom built non-combustible
enclosure)
with the grate facing the
front of the fireplace.
9
BURNER ASSEMBLY INSTRUCTIONS
6.
Make sure the gas connections are tight. Turn on the gas and coat each joint with a soap and water solution
5. Test functionality of the Log Set burner (see "Operating Instructions") before placing logs.
the media and the pilot is not blocked with loose pieces of glass.
Make sure the flame is tall, steady, and yellow. Ignition time should not exceed 5-7 seconds.
R
emove
grate from the box and place onto the base with rear legs positioned inside of support brackets.
7.
DO NOT
REMOVE
ANY LOG
S FROM ORIGINAL PACKAGING TILL STEP #
7
AS BREAKAGE
Fill the burner tray with the supplied glass media. Make sure the burner is completely covered with
8.
Carefully position logs over the burner grate. Start with placing the largest Log #1 behind the rear set of
vertical tabs welded on the grate. Then place large Logs #2 and #3 in front of the nearest row of the vertical
front and rear logs.
Continue with the rest of the logs following the recommended positioning shown on the next
page(s).
tabs welded on the grate. Make sure all three logs are secured on the grate with appropriate gap between
WARNING
within the appliance.
Do
not operate
the
appliance without the burner being completely filled with glass media.
Lighting the burner without the glass media will cause unsafe temperatures
