Timer Mode Operation
When the timer is programmed for “ON/OFF” mode operation and the time of day reaches the programmed 'ON'
time, the appliance controls will be switched on and the clock face icon will flash until the off time is reached, at
which time the clock face icon will go off.
• If the appliance is turned on manually while the timer is set, the clock face icon will start flashing indicating
the “OFF” function is still enabled, and the appliance will still shut off at the preset time.
• If the appliance is manually turned off before the preset time is reached, the preset time will be overridden
and the clock face icon will go out.
Minute (Countdown) Timer Operation
To set the countdown time
• Press and hold either the Hr or Mn button for 5 seconds. The display will start flashing “0:00”.
• Use the Hr and Mn button to set the desired countdown time. The display will continue to flash the count-
down time.
• To start the countdown timer, press the ON button once. The display will show solid with only the colon flash-
ing at a rate of once per second, showing the timer is running.
• When the timer counts down to “0:00”, the beeper will sound 1 second on and one second off for 30 seconds
The timer will then beep once every 10 seconds until it is reset by pressing the OFF button.
• Pressing the OFF button will silence the beeper and the display will revert to clock mode showing the time of
day.
• The timer function can be canceled by holding the ON and OFF buttons down at the same time for 5 seconds.
Clock/Timer Operation During a Power Outage
In the event of a power outage, the clock will continue to display the correct time for several hours. The minute
timer may be used during a power outage, but the beeper will not sound. Programmed ON/OFF times will remain
active unless the programmed ON time is reached before power is restored, in which case the program will be
canceled and the clock face icon will go out. If power is restored before the programmed ON time is reached, the
appliance will work normally at the preset times.
If the power remains off for an extended period the clock will eventually turn off (go blank) and will flash “AM
12:00” once the power is restored and must be reset per the instructions in the Initial Power Up/Clock Set Up
section above.
External Control
If the appliance is turned on manually when the timer is programmed for ON/OFF times, the ON time will be
canceled, but the OFF time will remain programmed. The clock face icon will blink to indicate this. If the appliance
is then turned off manually the OFF time will be canceled and the clock face icon will go out.
Setting the Flame Height
When programming the oven to turn on automatically it is also important to consider the proper setting of the
flame height. If the flame is turned up all of the way you may get the oven too hot too fast. If the flame is set too
low, the oven may not reach the desired temperature. As a starting point, we’d recommend programming the
oven to turn on three hours before you are planning to use it with the Flame Height Control Knob set to 3.
An ongoing program of product improvement may require us to change specifications without notice.
40
Bistro Home Oven Installation and Operation Manual
woodstonehome.com
tf. 800.578.6836
f. 360.734.0223
Wood Stone Corporation
1801 W. Bakerview Rd.
Bellingham, WA 98226 U.S.A.
M0003.06
Rev. July 2015
Programming