INTRODUCTION
Machine Description
INTRODUCTION
doc101521
1-4
1
SPACER RINGS THAT ARE SUPPLIED:
3 x 40 mm height (per cutter)
2 x 20 mm height (per cutter)
2 x 10 mm height (per cutter)
1 x 5 mm height (per cutter)
1 x 2 mm height (per cutter)
1 x 1 mm height (per cutter)
1 x 0.5 mm height (per cutter)
1 x 0.3 mm height (per cutter)
1 x 0.2 mm height (per cutter)
1 x 0.1 mm height (per cutter)
These spacer rings are necessary to set the required height.
CHIP EXTRACTOR
The MF130 Moulder must be connected to a chip extractor with a total capacity of at least 1000m
3
/h.
Remember that the chip container has to be equipped with an air vent (e.g. a fine net or filter if dust is
collected indoors). Poor suction is often caused by poor airflow from the chip container. During work in
heated rooms, it is necessary to remember that the fan will quickly cool the space if the filtered air is not
supplied back into the building. The fire risk and dust emissions (discharge) must be considered
because of chip collection.
WARNING!
There is a risk of fire and dust emission because of chip
collection.
Contact the local authorities for advice about designing the chip collection system to conform to the
national rules.
It is necessary to set the fan so that it is easy to reach the switch.
IMPORTANT!
Remove the chips from the Moulder when the work is
finished.
TECHNICAL REQUIREMENTS FOR THE CHIP EXTRACTOR
1
1. EN 12779:2016-04 standard contains requirements for chip and dust extraction systems equipment with
fixed installations.
!