Sawmill Operation
Unit of Measure
Sawmill Operation
60HD-Rdoc072619
4-16
4
Unit of Measure
This setting allows to choose what units of measure, temperature and pressure are used
when operating the DCS control. From the Regional Settings/Head Calibration menu,
select Unit of Measure Settings and push the CHECK button to enter. Use the UP/DOWN
arrows at the bottom to select the setting. Use the UP/DOWN buttons to change the set-
ting. Push the SAVE button to save the changes and exit.
See Figure 4-12.
PID (Proportional - Integral - Differential)
These settings allow a technician to diagnose and fine-tune the DCS control for various
environmental factors. These settings are made at the factory and should not normally
need adjusting by the operator.
FIG. 4-12
D
C
S
D
C
S
istributed
ontrol
ystem
istributed
ontrol
ystem
600337-3
Unit of Measure Settings
Temperature: Fahrenheit
Pressure: psi
Length:
Inches (##-##/##)
Push SAVE
button to save
changes and exit
Push UP/DOWN
button to change
setting
Push UP or DOWN
arrow to highlight setting