SETUP & OPERATION
Middle Track Cover
2
2-6
25doc092506
SETUP & OPERATION
2.3
Middle Track Cover
Before operating the sawmill do as follows:
1.
Clean the upper and lower rails to remove any sawdust and rust preventives.
2.
Unbolt and remove the middle track cover from its storage position.
3.
Soak the felt wiper with Dexron III transmission fluid, 10W30 motor oil or 3-in-1 turbine oil.
4.
Install the middle track cover so it fits against the rail and secure with two thumb screws.
See Figure 2-6.
CAUTION!
Install the track cover so that it lightly touches
the track rail. If the wiper presses too firmly against therail,
it can cause the power feed to bind.
FIG. 2-6
Install the track cover and
secure with two thumb screws
