Setup & Operation
Sawmill Setup
3
3-4
15doc080213
Setup & Operation
See Figure 3-3.
Make sure the entire face of each slide pad makes contact with the mast. Use the
adjustment nuts shown below to adjust the slide pads if necessary.
9.
Check the vertical alignment of each blade wheel using the blade guide alignment tool.
Attach the tool to the blade near the outer blade guide. Be sure the tool does not rest on a
tooth or burr, and is lying flat on the blade.
See Figure 3-4.
Move the saw head so the front end of the tool is positioned over the first bed rail. Measure
from the bottom of the tool to the top surface of the bed rail.
Move the saw head so the rear of the tool is positioned over the bed rail. Again, measure from
the bottom of the tool to the bed rail.
If the two measurements differ by more than 1/16” (1.5 mm), adjust the vertical tilt of the
FIG. 3-3
FIG. 3-4
Slide Pad Adjustment Nuts (4)
Clip tool to blade
SM0069