Sawmill Assembly
Saw Carriage Assembly
8
8-11
1597doc111810
Sawmill Assembly
8.7
S
aw Carriage Assembly
The saw carriage is equipped with two lock pins at the bottom of the mast near the track
rollers. These pins can be adjusted to three different positions:
1. Assembly/Disassembly position (prior to Rev. E1.00 only).
To move the pins so they
do not interfere with installing the carriage to the bed frame, rotate both pins so they rest
in the upper notch on the pin bracket.
2. Operation position.
This position allows the pins to catch the bottom of the track rail,
preventing the saw head from tilting and disengaging the bed frame.
NOTE (Rev. D6.00+
Only):
The pins are designed so if they are inadvertently left in the assembly position,
they will move to the operation position when the carriage is moved.
3. Travel position.
To secure the saw head to the bed frame during travel, rotate the pin at
the end of the sawmill so it is clear of the pin bracket. Be sure the pin engages the hole in
the bed frame tube. The other pin should remain in the operation position to prevent the
saw head from tilting.
See Figure 8-11.
FIG. 8-11 REV. A1.00 - D5.00
150082-2B
Travel
Operation
Assembly/
Disassembly
Pull, rotate and
release pin to
appropriate position
(See Detail)
DETAIL
1
2
3